Search results
Jump to navigation
Jump to search
Create the page "EPIC" on this wiki! See also the search results found.
- known as EPIC. EPIC I - TTN4094 EPIC II - CLN6686F EPIC III - Note the EPIC3 will not work out of band. The modulation will be very low. EPIC IV - This28 KB (2,928 words) - 00:11, 4 May 2024
- ASTRO-TAC (section EPIC II CCN4009)converter used to power RPi's and works fine. The controller is based around the EPIC SCM, but with the addition of a 68EC040RC33B 68k uP. I've used the 25mhz9 KB (1,026 words) - 14:04, 26 February 2024
- PDR 3500 (section EPIC V SCM)wire Wireline card in them. Most were later production modules so they have EPIC V modules. It is possible to add a v.24 card on these and route the v.2414 KB (1,021 words) - 01:34, 13 March 2024
- I have. EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board2 KB (188 words) - 18:30, 4 April 2019
- Control Module Epic 1 Schematic Diagram Page 2 of 10 Station Control Module Epic 1 Schematic Diagram Page 3 of 10 Station Control Module Epic 1 Schematic2 KB (249 words) - 22:52, 30 November 2016
- Motorola. Quantar EPIC II SCM Full Frontal Quantar EPIC II SCM EEPROMs Quantar EPIC II SCM 27C040 Quantar EPIC II SCM CLN6686F Quantar EPIC II SCM CLN6686F751 bytes (82 words) - 17:22, 22 March 2022
- IN 6809 TRUNKING SYSTEMS, THERE IS A RESISTOR THAT NEEDS TO BE CHECKED. IN EPIC MODULES TTN4094B & C WHEN USED IN SIMULCAST APPLICATIONS, THE RESISTOR R12169 KB (0 words) - 06:12, 28 March 2019
- should be checked on the intended frequency's after alignment. If you have the EPIC 3 SCM it will not work outside the frequency limits of 935-941 MHz, and there13 KB (2,000 words) - 22:50, 30 November 2016
- INCOMPATIBILITY BETWEEN NEW MOTOROLA POWER SUPPLIES AND CERTAIN OLDER NON-EPIC STATION CONTROL BOARDS. MODELS AFFECTED: QUANTAR T5331A, T5365A, T5542A14 KB (398 words) - 05:54, 28 March 2019
- (T5770A) SYSTEMS AFFECTED: ANY SYSTEM CONTAINING QUANTAR/QUANTRO STATIONS WITH EPIC STATION CONTROL MODULES. STATION CONTROL MODULES AFFECTED: CLN6686A, CLN6873A4 KB (475 words) - 05:57, 28 March 2019
- SmartZone IR ASTRO CAI Trunking X999 SmartZone IntelliRepeater CLN1294 FRU – EPIC-II IR station control module SYMPTOMS: Adding multiple new IR channels38 KB (1,319 words) - 06:34, 28 March 2019
- | R5.00 | | | | | | | | | | SC B013.05.007 | SCM U651 | 5191020H09 | | | EPIC | SCM U652 | 5191020H10 | | | | SCM U653 | 5191020H11 | | | | SCM U654 |708 KB (102,209 words) - 04:31, 7 February 2024