Search results
Jump to navigation
Jump to search
Create the page "ATAC" on this wiki! See also the search results found.
- I can tell as it's what I had on hand. The below controller is out of an ATAC 9600, but could be used in a 3000. Like other products in the Quantar family9 KB (1,026 words) - 14:04, 26 February 2024
- you're doing an ATAC 3k, the ATAC does care about this and you need pins 76 and 79 tied to ground. Of course the Intelerepeater and ATAC9k will not work28 KB (2,928 words) - 00:11, 4 May 2024
- This is only pin 76 brought low/ground. Note the ATAC does care about this being set. If converting to a ATAC 3000, Only the first bank is needed. The 96002 KB (244 words) - 00:14, 4 April 2019
- Wireline (category ATAC)boards supported in the ATAC comparator. All these support the auto upgrading of firmware to match the SCM version. In the ATAC the Firmware is on a AM29F002NBB5 KB (438 words) - 17:10, 6 July 2020
- Quantro/Quantar-Backplane (category ATAC)This handles all the interconnect to the units modules and additionally in the Quantro discrete interconnects to the IPA which are behind the PA. The Telco2 KB (159 words) - 07:57, 6 April 2019
- is : Internet -------- DMVPN -------- STUN and G.711 VOIP circuits -------- ATAC and Quantars What's presented here assumes each site has a stable IPv4 internet21 KB (2,953 words) - 11:09, 17 March 2021
- and control traffic arriving at the ATAC3000 to all other console/DIU ports. When this parameter is disabled the ATAC3000 will not route console/DIU port708 KB (102,209 words) - 04:31, 7 February 2024