COIM Modification

The Motorola Console Operator Interface Module (COIM) uses a 18 bit wide (0x40000) bus address bus supporting 4 256kb flash chips. The Quantar uses a 19 bit wide address bus (0x80000) for 512k flash chips. The chips are almost identical so the board only needs a few simple modifications.

The modification is easy:

1. Remove 5 caps on the back closest to SIMM contacts
2. Remove the 0 Ohm resistor above U8 silkscreen
3. Remove 3 caps on front closest to SIMM contacts
4. Move 4, 0 Ohm resistors on front closer to SIMM contacts
5. Install a jumper on the back from pin 34 to second pad above silkscreen "U7". This should be Pin 1 of the chips.
6. Depending on if this is a conventional or InteliRepeater SIMM install jumpers as follows
   1. If Conventional install jumpers from 80,79,75,74,73
   2. If IR SIMM install jumpers from 80,79,76
7. Install the proper 29F040B-90 PLCC Flash memory chips and program. The Conventional SIMM only needs U1-U4 populated

• 

  SIMM Back

• 

  SIMM Front

The COIM SIMM is available from Motorola for about $40, Part number BLN7062D.

There are programmed SIMMs being sold on eBay as of December 2015 for $75.