Difference between revisions of "XTL Radio"

From W9CR
Jump to navigation Jump to search
Line 216: Line 216:
  
 
== Mid Power Flex detail ==
 
== Mid Power Flex detail ==
<gallery>
+
<gallery mode=packed-hover>
 
XTL_Mid-power_Flex-00001.JPG
 
XTL_Mid-power_Flex-00001.JPG
 
XTL_Mid-power_Flex-00002.JPG
 
XTL_Mid-power_Flex-00002.JPG
Line 222: Line 222:
 
XTL_Mid-power_Flex-00004.JPG
 
XTL_Mid-power_Flex-00004.JPG
 
</gallery>
 
</gallery>
 
 
  
 
= Manuals =
 
= Manuals =

Revision as of 18:26, 12 May 2020

Page covering the XTL 1500/2500/5000 Radios

These are P25 trunking radios which are mono-band.

Accessory Connector

J2 is the accessory connector

Here's a picture of it from the radio side

XTL Accessory Jack Picture Radio Side, aka J2

Table of Pins

Rear Accessory Jack Pin Functions
Pin Name Function
1 GRND Ground
2 BUS+ SB9600 BUS+ Data
3 BUS1 SB9600 BUS- Data
4 TXD RS232 Transmit Data
5 RXD RS232 Recieve Data
6 USB- USB - (White)
7 USB+ USB + (Green)
8 RESET SB9600 Reset
9 BUSY SB9600 BUSY
10 CTS RS232 Clear to Send
11 RTS RS232 Request to Send
12 USB PWR USB Power +5v
13 CHAN ACT Chanel Activity (COR+PL
14 GRND Ground
15 EMERGENCY Emergency
16 PTT Push to Talk
17 ONE WIRE One-Wire Data
18 VIP OUT 1 Vehicular Interface Output 1
19 VIP OUT 2 Vehicular Interface Output 2
20 SPKR+ Speaker+
21 RX FILT AUDIO Receive Filtered Audio Out
22 Monitor Monitor Overrides PL
23 AUX MIC Rear Mic Input
24 SW B+ Switched Battery Voltage
25 IGN Ignition Sense
26 SPKR Speaker -

Sourcing of connector

As of now, there is no other source for the connector than Motorola. The rumor mill puts money on ITT Canon being the manufacturer.

The pins come in a 25 pin strip Motorola Part Number: 3980034F05

The housings are HLN6961

The body looks like 2 D-Sub connectors stacked with standard pitch spacing on the pins.

Aftermarket Pins will not work due to the low profile retaining ring. This thread on the Batlabs Batboard has some more info and this picture showing the differences below:

XTS accessory Pin detail vs. normal pins

Notes on assembly

The TE 91285-1 Pin extraction tool is highly recommended. DigiKey Link

The Engineer PA-09 is recommenced as a crimper.

Photos of connector

I disassembled and took some close up pictures with my scope. The connector looks a bit similar to most D-SUB connectors.

Pictures of Radios

Brick and TIB

TIB

Control Head Interface


XTL 2500 900 MHz Internal PCB

Control head interface

O series Transceiver Interface Board (TIB)

Mid Power Flex detail

Manuals

Xtl-1500-install-manual-6815851h01-o
XTL2500 Detailed Service Manual
XTL5000 Basic Service Manual