Page covering the XTL 1500/2500/5000 Radios
These are P25 trunking radios which are mono-band.
- 1 Accessory Connector
- 2 Global Core Accessory Interface ("GCAI")
- 3 Operational notes
- 4 Pictures of Radios
- 5 Manuals
J2 is the accessory connector
Here's a picture of it from the radio side
Table of Pins
|Rear Accessory Jack Pin Functions|
|2||BUS+||SB9600 BUS+ Data|
|3||BUS1||SB9600 BUS- Data|
|4||TXD||RS232 Transmit Data|
|5||RXD||RS232 Recieve Data|
|6||USB-||USB - (White)|
|7||USB+||USB + (Green)|
|10||CTS||RS232 Clear to Send|
|11||RTS||RS232 Request to Send|
|12||USB PWR||USB Power +5v|
|13||CHAN ACT||Chanel Activity (COR+PL|
|16||PTT||Push to Talk|
|17||ONE WIRE||One-Wire Data|
|18||VIP OUT 1||Vehicular Interface Output 1|
|19||VIP OUT 2||Vehicular Interface Output 2|
|21||RX FILT AUDIO||Receive Filtered Audio Out|
|22||Monitor||Monitor Overrides PL|
|23||AUX MIC||Rear Mic Input|
|24||SW B+||Switched Battery Voltage|
The below is how the XTL's installed in my vehicle are connected:
26,20 - speaker 14-15 - Jumper for Emergency 7 - USB + (Green) 6 - USB - (White) 1 - USB Ground (Black) 12 - USB 5V (Red) 25 - Ignition Sense Control Head: Red - Constant 12v Yellow - Ignition 12v Black - Ground
Sourcing of connector
As of now, there is no other source for the connector than Motorola. The rumor mill puts money on ITT Canon being the manufacturer.
The pins come in a 25 pin strip Motorola Part Number: 3980034F05
The housings are HLN6961
The body looks like 2 D-Sub connectors stacked with standard pitch spacing on the pins.
Aftermarket Pins will not work due to the low profile retaining ring. This thread on the Batlabs Batboard has some more info and this picture showing the differences below:
Notes on assembly
The TE 91285-1 Pin extraction tool is highly recommended. DigiKey Link
The Engineer PA-09 is recommenced as a crimper.
Photos of connector
I disassembled and took some close up pictures with my scope. The connector looks a bit similar to most D-SUB connectors.
Global Core Accessory Interface ("GCAI")
This is the connector used for mic jacks and such. It's also used to keyload on the brick (remote mount) or via the control head (dash mount).
|CGAI Pin Functions|
The 900 MHz radio has an option for the pre-amp, you want this enabled.
The other concern for 900 MHz was the preselector B7250, and it's the same device from the MCS2000. Motorola describes it as a 6 MHz wide unit centered on 938 MHz, and then another follow the pre-amp for an image filter. In testing with a tracking generator it was found roll-off didn't happen until about 915 MHz and 960 MHz. This should be (and is) a fine ham band receiver.
The programing info for modifying CPS to program the hamband is on the XTS 2500 page.
Pictures of Radios
Brick and TIB
Control Head Interface