Search results

Create the page "UHF R0 Exciter" on this wiki! See also the search results found.

• 800 MHz Exciter
  covers the 800 MHz exciter in technical detail. This exciter is similar to the 900 MHz exciter and shares the VCO design. The UHF R0 exciter has this same sort
  13 KB (2,000 words) - 22:50, 30 November 2016
• Quantar (section Exciter Images)
  110W Power Amplifier UHF R1 TTE2062A 110W Power Amplifier UHF R2 TTE2063A 110W Power Amplifier UHF R3 TTE2064A 110W Power Amplifier UHF R4 TLE2511A/ 110W Power
  27 KB (2,894 words) - 04:37, 7 February 2024
• Second Generation PA (section R0 to R2)
  Diagram 1 R0 Distribution Board R0 Distribution/Amp board R0 Distribution Board Layout This is a UHF R0 Generation 2 PA I took pictures of. Quantar UHF Range
  7 KB (863 words) - 22:50, 30 November 2016
• UHF Exciter (section Exciter)
  The UHF R1-R4 exciter are based on a common design. UHF R0 is a newer design covering 380-433 MHz. Test it first! Trying to modify a broken exciter is like
  9 KB (1,610 words) - 23:48, 13 December 2016
• First Generation PA (section R3 to R4 or R4 to R3)
  The Quantar First Generation UHF Power Amps cover UHF R1, R2, R3 and R4. R0, 380-433 MHz, was a slight redesign, and it is covered else where. The Basic
  7 KB (806 words) - 22:50, 30 November 2016
• UHF R0 Receiver (section R0 to R1)
  that you have a UHF R0 from the front. UHF RX R0 Front UHF RX Back UHF RX Case UHF RX Internal This receiver was designed after the R1-R4 receivers and
  16 KB (2,185 words) - 22:48, 30 November 2016
• UHF Receiver (section R1 to R2)
  the VCO in the exciter, a sealed unit with no further diagram available from the factory. UHF R2 RX VCO Case on UHF R2 RX VCO case off UHF R2 VCO Close up
  17 KB (1,854 words) - 18:34, 8 April 2024
• Quantar UHF RX conversion (section R1 to R2)
  first amplifier stage, loss here is not a huge problem. UHF R1 to R2 RX FILTER no table UHF R1 to R2 RX FILTER There is no difference in sensitivity, but
  13 KB (1,906 words) - 04:33, 27 March 2024
• PDR 3500 (section UHF R1 PA Module)
  were common for FBI/USSS/WHCA meaning the UHF1 was the most common (403-433), but they can be changed to UHF 2 with a module swap or via converting the
  14 KB (1,021 words) - 01:34, 13 March 2024
• MTR Repeater (section MTR2000 VHF Exciter)
  SCM MTR 2000 Exciter VHF 01 MTR 2000 Exciter VHF 02 MTR 2000 Exciter VHF 03 MTR 2000 Exciter VHF 04 MTR 2000 Exciter VHF 05 MTR 2000 Exciter VHF 06 MTR 2000
  17 KB (1,770 words) - 12:40, 3 July 2022
• Allstar® and P25 on Quantar
  interface Serial0/0/1 no ip address shutdown clock rate 125000 ! router ospf 1 network 10.2.4.130 0.0.0.0 area 0 network 172.21.4.130 0.0.0.0 area 0 network 172
  70 KB (4,418 words) - 15:16, 16 May 2020
• Winrss help (section EXCITER DIAGNOSTIC TESTS HELP)
  toggle choices are: UHF Range 0, UHF Range 1, UHF Range 2, UHF Range 3, UHF Range 4, VHF Range 1, VHF Range 2, 800 MHz, 900 MHz, and NONE. UHF Range 0 is only
  708 KB (102,209 words) - 04:31, 7 February 2024
• 800 MHz Receiver
  The preselector is soldered on to the board and not tune-able as in the VHF/UHF modules. 800 MHz Receiver - 0241 800 MHz Receiver - 0242 The receiver is a
  19 KB (2,633 words) - 22:49, 30 November 2016