Search results

Create the page "EPIC" on this wiki! See also the search results found.

• Quantar
  known as EPIC. EPIC I - TTN4094 EPIC II - CLN6686F EPIC III - Note the EPIC3 will not work out of band. The modulation will be very low. EPIC IV - This
  27 KB (2,894 words) - 04:37, 7 February 2024
• ASTRO-TAC (section EPIC II CCN4009)
  converter used to power RPi's and works fine. The controller is based around the EPIC SCM, but with the addition of a 68EC040RC33B 68k uP. I've used the 25mhz
  9 KB (1,026 words) - 14:04, 26 February 2024
• PDR 3500 (section EPIC V SCM)
  wire Wireline card in them. Most were later production modules so they have EPIC V modules. It is possible to add a v.24 card on these and route the v.24
  14 KB (1,021 words) - 01:34, 13 March 2024
• EPIC V (section EPIC V)
  I have. EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board EPIC V Board
  2 KB (188 words) - 18:30, 4 April 2019
• EPIC 1
  Control Module Epic 1 Schematic Diagram Page 2 of 10 Station Control Module Epic 1 Schematic Diagram Page 3 of 10 Station Control Module Epic 1 Schematic
  2 KB (249 words) - 22:52, 30 November 2016
• EPIC II
  Motorola. Quantar EPIC II SCM Full Frontal Quantar EPIC II SCM EEPROMs Quantar EPIC II SCM 27C040 Quantar EPIC II SCM CLN6686F Quantar EPIC II SCM CLN6686F
  751 bytes (82 words) - 17:22, 22 March 2022
• Product Support Bulletin 755
  IN 6809 TRUNKING SYSTEMS, THERE IS A RESISTOR THAT NEEDS TO BE CHECKED. IN EPIC MODULES TTN4094B & C WHEN USED IN SIMULCAST APPLICATIONS, THE RESISTOR R1216
  9 KB (0 words) - 06:12, 28 March 2019
• 800 MHz Exciter
  should be checked on the intended frequency's after alignment. If you have the EPIC 3 SCM it will not work outside the frequency limits of 935-941 MHz, and there
  13 KB (2,000 words) - 22:50, 30 November 2016
• Product Support Bulletin 872A
  INCOMPATIBILITY BETWEEN NEW MOTOROLA POWER SUPPLIES AND CERTAIN         OLDER NON-EPIC STATION CONTROL BOARDS.   MODELS AFFECTED:   QUANTAR T5331A, T5365A, T5542A
  14 KB (398 words) - 05:54, 28 March 2019
• Product Support Bulletin 922
  (T5770A) SYSTEMS AFFECTED: ANY SYSTEM CONTAINING QUANTAR/QUANTRO STATIONS WITH EPIC STATION CONTROL MODULES.  STATION CONTROL MODULES AFFECTED:  CLN6686A, CLN6873A
  4 KB (475 words) - 05:57, 28 March 2019
• Service and Repair Notes S-0164
  SmartZone IR ASTRO CAI Trunking X999 SmartZone IntelliRepeater CLN1294 FRU – EPIC-II IR station control module   SYMPTOMS:  Adding multiple new IR channels
  38 KB (1,319 words) - 06:34, 28 March 2019
• Winrss help
  | R5.00 | | | | | | | | | | SC B013.05.007 | SCM U651 | 5191020H09 | | | EPIC | SCM U652 | 5191020H10 | | | | SCM U653 | 5191020H11 | | | | SCM U654 |
  708 KB (102,209 words) - 04:31, 7 February 2024